Autodesk Inventor 2021 is packed with customer-driven updates and enhancements to help you speed up your design workflows, reduce repetitive tasks, and improve experiences so you can. Typically I will be using this to place the views of plates and other members for welded structures. Not all of these parts need to be detailed (for example, a simple rectangular plate), because they are fully described in the parts list. The preview thumbnail in the QuickViews dialog box would typically be all I need to recognize which parts need a view and which ones don't. However, the preview images often fail to load for me. Switching back and forth between different selected parts will eventually cause it to load. To see the updated mesh, click Mesh View.This is annoying, but it still gets the job done faster than my previous method of individually opening up each part file to check it for the need to detail and then placing the view if required.After you change mesh settings, on the mesh node context menu, click Update Mesh.Useful for assemblies composed of many parts of different sizes. In assemblies, sets part mesh sizes to be like the part based context (part outside the assembly context). Use a finer mesh in the stress concentration area around a concave fillet or round to compensate for the lack of curvature. When cleared, produces meshes with straight elements, which can be a less accurate representation of the model.

The smaller the angle, the greater the number of mesh elements on a curve.Ĭreates meshes with curved edges and faces.

For example, a setting of 1.5 limits an elements edge length to 1.5 times the edge length of the adjacent element.Įffects the number of elements on curved surfaces. Specifies the maximum edge length ratio between adjacent element edges. The value is relative to the Average Size.ĭefault 0.2 Recommended Between 0.1 and 0.2Įffects the uniformity of the mesh transition between fine and coarse mesh. Specifies the element size relative to the model size.Īllows for automatic refinement in small areas. Smaller mesh elements take longer to simulate. These parameters specify the mesh sizing and coarseness.

To view mesh settings, on the Ribbon: Stress Analysis tab Mesh panel, click Mesh Settings.For Parametric Dimension simulations, one mesh setting applies to all parameter ranges. Mesh settings are established for each simulation, and apply to the component in a global sense.

Mesh enabler inventor 2021 download